UK
Lanbowo 50KHz-900MHz Vector Networks Analyzer Kit MF HF VHF UHF Antenna Analyzer Tool
by LanbowoLast refresh Aug/17/2019 12:07 PM
Description:
It is a DIY vector network analyzer. It features a 2.8-inch touchscreen, 400mAh electricity for off-line application in 2 hours. If you want to prolong the testing time, you can connect it to an extra power bank, or contact us for larger capacity. As for testing via TX/RX, you can get full set of parameters of S11 and S21. What you have to do is to replace the connection cables in the receiving and transmitting ports.
Basic Parameters:
PCB: 54mm x 85.5mm x 11mm (without the size of connectors, switches)
Measurement Frequency: 50KHz-300MHz (50KHz -900MHz, enable extended firmware)
RF Output: -13dbm (maximum -9dbm)
Frequency Accuracy: 0.5ppm
Measurement Range: 70dB (50kHz-300MHz), 50dB (300M-600MHz), 40dB (600M-900MHz) enable extended firmware)
Port SWR: < 1.1
Display: 2.8 inch TFT (320 x240)
USB Interface: USB Type-C; Communications Mode: CDC (Serial)
Power Supply: USB 5V 120mA, built-in 400mAh electricity, maximum charging current 0.8A
Number of Calibration Points: 101 (Fixed)
Number of Scanning Points: 101 (Fixed)
Display Tracking: 4, Marking: 4, Save Setting : 5
Measuring S parameters, voltage standing wave ratio, phase, delay