UK
3D Pen, Tecboss 3D Intelligent Drawing Printing Pen with 2 Pack PLA Filaments
by TecbossNew from:
£21.99
Shipping:
see website
Prices may incl. VAT *
Last refresh Feb/19/2019 12:08 PM
Last refresh Feb/19/2019 12:08 PM
or
or
Brand
Tecboss
Tecboss Upgraded 3D Pen to draw your dreams on your way!
Specification:
Output power: DC 5V / 2A 10W
Compatible filaments: 1.75mm PLA
How to use Tecboss M1 3D Pen
1.Connect the power and press to heat up.
2.Connect the operating key, start heating until the lower indicator turns red into green. Then click on the operating key again to load the filament. (Cut off the top of the material to make the flat cuts, then gently push the filament until it passes through the gear.)
3. After use, long press the operation button for 3 seconds to discharge the filament. If you want to change the filament mode, cut the power and choose the filament mode again. (To avoid the pen clogging
Specification:
Output power: DC 5V / 2A 10W
Compatible filaments: 1.75mm PLA
How to use Tecboss M1 3D Pen
1.Connect the power and press to heat up.
2.Connect the operating key, start heating until the lower indicator turns red into green. Then click on the operating key again to load the filament. (Cut off the top of the material to make the flat cuts, then gently push the filament until it passes through the gear.)
3. After use, long press the operation button for 3 seconds to discharge the filament. If you want to change the filament mode, cut the power and choose the filament mode again. (To avoid the pen clogging
Latest products for Price Comparison
* The prices and shipping costs may have changed since the last update. It is technically not possible to update the prices in real time. The time of purchase on the Website of the seller is used as the reference.